Trailing Arm Removal / Installation - Polaris RZR XP Turbo Service Manual

TRAILING ARM REMOVAL / INSTALLATION

NOTE
Use new attaching nuts upon installation of the rear
trailing arm and bearing carrier.
1. Raise and support vehicle by main frame.
WARNING
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure.
2. Remove the four wheel nuts and remove the rear
wheel.
q
3. Remove the cotter pin
w
hub castle nut . Remove the nut, and two cone
e
washers from the rear wheel hub assembly.
4. Remove the lower radius rod mounting bolt
and washer from the bearing carrier. Swing radius rod
down. Discard the nut.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
and loosen the rear wheel
r
, nut
STEERING / SUSPENSION
5. Remove the two brake caliper mounting bolts
Discard bolts.
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.
6. Remove the rear wheel hub and brake disk assembly.
7. Remove the five remaining bolts
rear bearing carrier to trailing arm. Discard the nuts.
8. Remove the bearing carrier from the rear drive shaft
and trailing arm.
t
.
y
that attach the
8
8.17