Break-Out Diagram Viewing - Polaris RZR XP Turbo Service Manual

13. Remove plastic rivets retaining the rear upper close-
y
off panel and lower close-off panel
14. Remove the front fender flairs.
15. Dynamix Models Only: Loosen front right fender to
allow harness to pass through by the fuse box.
16. Remove coolant reservoir bottle fasteners.
17. Disconnect the wiring harness from all sensors and
controls.
18. Removal all harness retaining clips from the chassis.
Refer to Main Harness Retention Locations, page
11.61.
19. Remove the harness through the front of the vehicle.
20. Route new harness the same way as the old harness.
Refer to Main Harness Routing, page 11.60.
21. Install all previously removed parts and torque
fasteners to specification.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.

BREAK-OUT DIAGRAM VIEWING

u
.
Break-Out Diagrams
The main wiring diagram(s) maybe found in the back of
the paper manual.
Break-Out diagrams for this model may be found in the
online service manual in with the main wiring diagrams.
To access the interactive break-out diagrams:
1. Open the wiring diagram PDF and open the left side
menu.
2. If the wiring diagram does not open the Adobe
navigation bars, click on the Adobe Icon.
3. Click on the Layers Icon.
ELECTRICAL
11
11.63