Rear Bearing Replacement - Polaris RZR XP Turbo Service Manual

FINAL DRIVE

REAR BEARING REPLACEMENT

Bearing Removal
1. Remove the outer snap ring
2. From the back side of the bearing carrier, tap on the
outer bearing race with a drift punch in the reliefs as
shown.
3. Drive bearing out evenly by tapping on outer race
only. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
4. Inspect the bearing carrier housing for scratches,
wear or damage. Replace rear bearing carrier if
damaged.
Bearing Installation
5. Thoroughly clean the rear bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
7.8
q
.
7. Apply Loctite ® 603
outer circumference of the new bearing race
carefully press the new bearing into the bearing
e
carrier housing .
Use care to not allow any of the Loctite
get in the bearing.
8. Wipe the housing clean of any excess compound
and install the snap ring
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
™ retaining compound to the
NOTE
® compound to
r
.
© Copyright Polaris Industries Inc.
w
and