Polaris RZR XP Turbo Service Manual page 369

33. Pressurize the shock
Schrader ® valve using the Gas Shock Recharging Kit
(PN 2200421).
34. Continue filling until the shaft has fully extended and
the reservoir pressure is at 125 psi.
Nitrogen Pressure (Front and Rear):
125 psi (862 kPa) +/- 5%
WARNING
CHARGE THE SHOCK USING NITROGEN GAS
ONLY. DO NOT FILL WITH ANY OTHER GASES.
Doing so compromises the performance of the shock
and may be EXTREMELY DANGEROUS!
35. Reinstall the valve cap.
36. Clean all oil residue from the shock and reservoir
with solvent, and dry with low pressure compressed
air in a well ventilated area.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
reservoir through the 37. Check shock for any leaks.
38. Reinstall the compression spring and the spring
39. Thread the spring preload adjuster down against the
40. Set
41. Remove the shock from the vise.
42. Reinstall spherical bearing O-rings and polyurethane
STEERING / SUSPENSION
NOTE
If leakage from a remote shock reservoir hose fitting is
evident, check for a loose fitting and seal threads with
Three Bond 1215 (PN 2871557)
retainer.
spring and set the preload to the specified
measurement (see Chapter 2 – Spring Adjustment).
the compression
recommended setting or the original setting upon
removal (see Chapter 2 – Shock Compression
Adjustment).
bushings.
NOTE
After installation, be sure to RIDE SLOWLY initially to
ensure the shock and the vehicle's suspension is
performing correctly.
adjuster knob to the
8
8.51