Regulator / Rectifier (Dynamix); Regulator Replacement - Polaris RZR XP Turbo Service Manual

ELECTRICAL
3. Remove the two fasteners
bracket to the frame.
4. Remove the two fasteners
to the bracket.
5. Install new regulator on the bracket. Torque fasteners
to specification.
TORQUE
Regulator Fasteners:
8 ft-lb (11 Nm)
6. Install the regulator bracket on the chassis. Torque
fasteners to specification.
TORQUE
Regulator Bracket Mounting Fasteners:
8 ft-lb (11 Nm)
7. Connect the two regulator harnesses.
8. Install the hood.

REGULATOR / RECTIFIER (DYNAMIX)

The dual regulator / rectifier assemblies are located
behind the front fascia grill in front of the radiator.
If the regulator / rectifier case temperature exceeds 230°
F or 110° C, the unit will turn itself off to cool down. The
11.36
e
retaining the regulator
r
retaining the regulator
unit will turn on again after it has cooled down to at least
212° F or 100° C. If it turns off, verify the cooling fins are
clean, free from debris and that adequate airflow is
present.

REGULATOR REPLACEMENT

1. Remove the seat and disconnect the negative battery
terminal.
2. Remove the front fascia grill cover by pulling down on
the two tabs to release it.
3. Disconnect the two wiring harnesses
regulator(s) being removed.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
q
going to the
© Copyright Polaris Industries Inc.