Polaris RZR XP Turbo Service Manual page 203

1. Retain the fuel vent line behind the fuel tank with a
q
hinge clip and a panduit strap
2. Route the fuel vent line OVER the electrical harness
e
and OVER the starter solenoid cables
3. Route the fuel vent line through the panduit strap
to the right side of the access panel. Retain the vent
q
line in the two hinge clips
4. Feed the vent line through the shock mount bracket
t
opening and attach the vent line to the fitting in the
y
frame .
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
VENT LINE TERMINATION FITTING
w
.
This fitting should be inspected and tested using a Mity
Vac™ to ensure proper venting. Connect the Mity Vac to
the fitting and give it 5 pumps. The gauge should return
to 0 immediately or there is an obstruction.
r
.
w
on the frame.
NOTE
If the vent line fitting is removed from the frame, it must
be replaced. The ears on the clip (arrows) will not hold
properly once it is removed.
EFI / FUEL SYSTEM
4
4.15