Polaris RZR XP Turbo Service Manual page 231

DATA DISPLAY
DEFINITION
ITEM
Indicates if the ECU
RPM Limit is currently limiting
Indicates what gear
position the
Selected Gear
transmission switch
Same as ignition
Spark Angle
ECU control of the
Start Enable Driver
start solenoid
RPM the ECU is
Target Idle RPM
attempting to get to
Throttle Body Indicates if the ECU
Initialization – has learned to
Learning Success
position of the ETC
How far open the
Throttle Position
throttle plate is
Throttle Limp-home ETC error and ECU
Operation Condition is limiting speed
Input to ECU to
Turf Mode Switch
indicate if turf mode
Input
is switch On or Off
How fast the
transmission output
Vehicle Speed
is turning (calculated
to wheel speed)
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
VALUE
Active
Inactive
RPM
dependent on gear
selected
is in
—
timing
Active
Inactive
varies
Yes
No
0–100%
Yes
No
Active
Inactive
varies
EFI / FUEL SYSTEM
VALUE DESCRIPTION
ECU is limiting the RPM
ECU is not limiting RPM
High, Low, Neutral, Reverse, Park
"–" or Null indicates no reading from the sensor /
stuck between gear positions
—
ECU is grounding the start solenoid. Unit should
crank when key is turned to START
ECU is not grounding the start solenoid
—
The ECU successfully learned the position of the
ETC when the engine was started.
The ECU failed to learn the position of the ETC
when the engine was started. Check throttle body
and connections. Cycle the key switch.
At warm idle, this can range from 0–3%
There is an error in the throttle control and the
vehicle is limiting
Normal Operation
ECU receiving a signal that the AWD switch is in
Turf Mode
ECU receiving signal that the AWD switch is in
AWD or 2WD mode
—
4
4.43