Drive Clutch Service; Drive Clutch Removal - Polaris RZR XP Turbo Service Manual

PVT SYSTEM

DRIVE CLUTCH SERVICE

DRIVE CLUTCH REMOVAL

1. Remove the three fasteners retaining the driver's side
rear shock guard.
q
2. Loosen the clamp
the outer clutch cover.
3. Remove the eight screws
clutch cover.
4. Maneuver the outer clutch cover outward as shown
below to access the drive belt.
Angle the rear of the clutch cover up and use a slight
rocking motion to work the clutch free when removing
the cover. There will be very little clearance.
5. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
6. Insert clutch spreader tool
and turn the tool clockwise to open the sheaves on
the driven clutch.
The driven clutch spreader tool is included with the
vehicle's tool kit
5.6
retaining the PVT inlet duct to
w
that retain the outer
NOTE
e
into the driven clutch
NOTE
7. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
8. Hold the drive clutch using the drive clutch holding
tool and remove the drive clutch mounting bolt.
Drive Clutch Holding Tool:
PU-51861
9. Remove the drive clutch using the correct drive clutch
puller.
Drive Clutch Puller:
2872085
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.