Polaris RZR XP Turbo Service Manual page 313

7. Remove the RH output hub assembly
gearcase housing.
o
8. Remove pinion seal , internal retaining ring
s
pinion gear assembly from the gearcase housing.
Inspect and clean the gearcase housing and replace
all oil seals and O-rings.
9. Inspect the pinion gear
missing teeth. Inspect the pinion bearing for signs of
wear and the pinion shaft seal surface for pitting.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
i
from the
a
, and
s
for chipped, broken or
d
10. Inspect the AWD coil
plate assembly. Refer to AWD Diagnosis, page 7.30
for detailed inspection process. Replace the cover
f g
plate seal and O-ring
11. Remove the roll cage assembly and rollers from the
clutch housing. Use a shop towel to cover the
housing in order to retain all the rollers.
NOTE
Rollers are spring loaded. Take care not to allow them
to fall out or lose them upon removal of the roll cage.
12. Thoroughly clean all parts and inspect the rollers
for nicks and scratches. The rollers must slide up
and down and in and out freely within the roll cage
sliding surfaces and H-springs.
NOTE
Refer to the "Electronic Parts Catalog" for individual
part availability. Most parts are to be replaced as an
assembly or as a complete kit.
13. Inspect clutch housing / ring gear
wear pattern. Inspect the ring gear for chipped,
broken, or missing teeth.
FINAL DRIVE
located in the outer cover
.
h
j
k
for a consistent
7.33
7