Polaris RZR XP Turbo Service Manual page 129

14. Install a NEW mechanical seal into the water pump
housing using special tool (PU-50564)
new mechanical seal in until it is flush with the water
pump housing.
15. Rotate water pump shaft after seal installation to
verify free movement.
16. Place impeller onto the water pump shaft.
17. Apply Loctite ® 204 ™ to the threads of the impeller
bolt. Install washer and impeller bolt and torque to
specification.
TORQUE
Water Pump Impeller Bolt:
7 ft-lb (10 Nm)(Apply Loctite® 204™ to bolt threads)
q
18. Clean cover and housing gasket surfaces
19. Install a new water pump cover gasket
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
20. Install the water pump cover and three retaining bolts
u
. Press the
i
. Torque bolts in sequence to specification.
7 ft-lb (10 Nm)(Apply Loctite® 204™ to bolt threads)
21. Install two new water pump (O-rings) and lubricate
them with fresh engine oil.
w
.
e
.
ENGINE / COOLING SYSTEM
TORQUE
Water Pump Cover Bolts:
3
3.37