Front Gearcase / Centralized Hilliard - Polaris RZR XP Turbo Service Manual

2. Install the support bearing isolator from the top side.
Lubricate the rubber isolator to ease with the install
over the prop shaft bearing.
3. Install the rear prop shaft from the bottom. Line up the
master spline on the front prop shaft to the rear shaft.
4. Install the rear prop shaft coupler on the transmission
output shaft. Torque new fasteners to specification.
TORQUE
Rear Prop Shaft Coupler Fasteners:
22 ft-lb (30 ft-lb)
IMPORTANT
The coupler fasteners have patch lock on the threads
and must be replaced any time they are removed.
5. Install the isolator mounting fasteners. Torque
fasteners to specification.
TORQUE
Prop Shaft Isolator Fasteners:
33 ft-lbs (45 Nm)
6. Install skid pan. Torque fasteners to specification.
TORQUE
Skid PlateFasteners:
8 ft-lbs (11 Nm)
7. Install new spring pin in prop shaft to the front
gearcase.
8. Install the front and rear center consoles. Torque
fasteners to specification.
TORQUE
Center Console Torx Fasteners:
8 ft-lb (11 Nm)

FRONT GEARCASE / CENTRALIZED HILLIARD

9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
FINAL DRIVE
7
7.27