Polaris RZR XP Turbo Service Manual page 172

ENGINE / COOLING SYSTEM
s
19. Install dowel pins into oil pump mounting holes.
20. Install the three bolts
crankcase. Torque mounting bolts to specification.
TORQUE
Oil Pump Mounting Bolts:
7 ft-lbs (10 Nm)
21. Reinstall oil pump pick-up
g
to specification.
TORQUE
Oil Pump Pick-Up Retaining Screw:
7 ft-lb (10 Nm)
22. Clean the gasket sealing surfaces on oil sump cover
and crankcase to remove old gasket material and any
oil.
Gasket surfaces must be DRY and oil free. Use care
upon assembly to keep oil away.
3.80
d
that retain oil pump to the
f
. Torque mounting screw
NOTE
23. Apply a thin, continuous film of Crankcase Sealant
(2871557) to sump cover mating surface and install
h
the oil sump cover
IMPORTANT
Do not allow sealant to dry before assembly.
24. Install the thirteen M6
retain the oil sump cover
25. Torque the oil sump cover bolts in sequence to
specification. Repeat the sequence to verify final
torque.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
onto the crankcase.
j
and three M8 bolts that
k
to the crankcase.
© Copyright Polaris Industries Inc.