Step 17. Install Forming Shield - MacDon R80 Manual

STEP 17. INSTALL FORMING
SHIELD
a. Retrieve forming shield bundles that were
removed from shipping locations in earlier
steps.
b. Remove banding and packing material.
A. INSTALL FINS
a. Remove hardware from forward ends of fins.
b. Position forming shield fins on header as
shown and secure with two bolts and nuts in
each fin. Do not fully tighten hardware.
Form # 169080
UNLOADING AND ASSEMBLY
B. INSTALL SIDE SUPPORTS
a. Disassemble the LH and RH deflector/support
b. Position side support (B) on header and
c. Repeat above step for opposite side support.
27
A
assemblies by removing two bolts (A) and nuts
from each assembly. Retain hardware.
B
secure with two existing bolts (C) and nuts.
Bolt heads should face inboard.
tighten.
C
Do not
Issue – April 2007