Step 8. Connect Lift Hose; Step 9. Connect Wiring Harness - MacDon R85 Unloading And Assembly Instructions

STEP 8. CONNECT LIFT HOSE
IMPORTANT
Hoses should be routed so there are no
twists or sharp bends, and no locations
where contact with the frame is likely.
Ensure that there is sufficient length of
hose and
accommodate full swing of APT hitch in
both directions.
Re-locate plastic ties if necessary to
provide suitable slack in hoses and
wiring.
IMPORTANT
To prevent
hydraulic system, extreme care must be
taken to avoid dirt entering at connection
points.
To minimize exposure to contamination,
remove cap from one hose and its
mating connection, and connect before
removing other caps and plugs.
A
B
a. Connect the lift cylinder hose (A) to the fitting
(B) on the hitch.
169561
UNLOADING AND ASSEMBLY
wiring in span
contamination of the
STEP 9.
to
a. Connect electrical wiring harness (C) at rear of
APT hitch as shown.
19
CONNECT WIRING
HARNESS
C
Revision C