Step 19. Install Options - MacDon R80 Manual

STEP 19. INSTALL OPTIONS

I. TALL CROP DIVIDER KIT
a. Unpack kit.
b. Open cutterbar doors.
c. Locate LH divider (A) on header LH front
corner and install with four bolts (B) and nuts in
existing holes. Tighten hardware.
d. Repeat for RH side.
Form # 169080
UNLOADING AND ASSEMBLY
B
A
II. SHOE LIFT KIT
a. Unpack kit.
b. Start tractor and raise header fully.
c. Stop engine, remove key, and engage lift
cylinder valves.
d. Install a lifts on each of the two end skid
shoes, and on two additional shoes at equi-
distant locations as follows:
B
3. Remove two bolts (A), pivot skid shoe (B),
and remove from slot (C) in rock guard.
D
E
4. Attach shoe lift (D) to skid shoe as shown
with hardware (E) supplied in kit. Tighten
bolts.
5. Position skid shoe (B) joggled end in rock
guard slot (C) and locate aft end with lift
(D) against rock guard.
existing bolts (A).
32
C
A
B
Secure with
Issue – April 2007