Running Summit Wm Series Spy Scans - Extreme Networks Summit WM User Manual

In the Poll interval box, type (in seconds) the interval that the Analysis Engine will poll the RF
Data Collector to maintain connection status. The default is 30 seconds.
In the Poll retry count box, type the number of times the Analysis Engine will attempt to poll the
RF Data Collector to maintain connection status, before it stops sending requests. The default is 2
attempts.
7 Click Add. The IP address of the Data Collection Engine, with its Poll Interval and Poll Retry
parameters is displayed in the list.
NOTE
For each remote RF Data Collection Engine defined here, you must:
- Enable it by selecting the Enable Summit Spy Analysis Engine checkbox on the remote Summit WM Controller
- Ensure that the controllers are routable by whatever means you use (for example, static routes, or OSPF).
8 To add a new collection engine, click Add Collection Engine.
9 Repeat steps 4 to 7.
10 To save your changes, click Apply.

Running Summit WM series Spy scans

The Summit WM series Spy feature allows you to view the following:
Scan Groups
Friendly APs
AP Maintenance
NOTE
A scan will not run on an inactive AP, even though it is displayed as part of the Scan Group. If it becomes active, it
will be sent a scan request during the next periodic scan.
Summit WM User Guide, Software Version 5.3
265