Modifying An Altitude Ap's Status - Extreme Networks Summit WM User Manual

Setting up 802.1X authentication for an Altitude AP
When configuring Altitude APs, you can choose to configure individual Altitude APs or simultaneously
configure a group of Altitude APs. For more information, see
simultaneously" on page

Modifying an Altitude AP's status

If during the discovery process, the Summit WM Controller security mode was Allow only approved
Altitude APs to connect, then the status of the Altitude AP is Pending. You must modify the security
mode to Allow all Altitude APs to connect. For more information, see
To modify an Altitude AP's registration status:
1 From the main menu, click Altitude AP Configuration. The Altitude APs page is displayed.
2 In the left pane, click Access Approval. The Access Approval page is displayed, along with the
registered Altitude APs and their status.
3 To select the Altitude APs for status change, do one of the following:
For a specific Altitude AP, select the corresponding checkbox.
For Altitude APs by category, click one of the Select Altitude APs options.
NOTE
You must consider all the three AP variants
To clear your Altitude AP selections, click Clear All.
Summit WM User Guide, Software Version 5.3
135.
-
Altitude AP, Outdoor AP, and Altitude 802.11n AP
"Configuring Altitude APs
"Security mode" on page 81.
-
as Local.
85