Extreme Networks Summit WM User Manual page 342

Regulatory information
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential and business environment. This
equipment generates, uses, and radiates radio frequency energy, and if not installed and used in
accordance with instructions, may cause harmful interference. However, there is no guarantee that
interference will not occur. If this equipment does cause harmful interference, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment or devices.
Connect the equipment to an outlet other than the receiver's.
Consult a dealer or an experienced radio/TV technician for suggestions.
USA Conformance Standards
This equipment meets the following conformance standards:
Safety
UL 60950-1
UL 2043 Plenum Rated as part of UL 60950-1. Suitable for use in environmental air space in
accordance with Section 300.22.C of the National Electrical Code.
EMC
FCC CFR 47 Part 15, Class B
Radio transceiver
CFR 47 Part 15.247, Subpart C (2.4 GHz)
CFR 47 Part 15.407, Subpart E (5 GHz)
Other
IEEE 802.11a (5 GHz)
IEEE 802.11b/g (2.4 GHz)
IEEE 802.311n (AP45x)
IEEE 802.3af (PoE)
WARNING!
The Altitude APs must be installed and used in strict accordance with the manufacturer's instructions as described
in this guide and related documentation for the device to which the Altitude AP is connected. Any other installation
or use of the product violates FCC Part 15 regulations.
Operation of the Altitude AP is restricted for indoor use only, specifically in the UNII 5.15 - 5.25 GHz band in
accordance with 47 CFR 15.407(e).
342
Summit WM User Guide, Software Version 5.3