Extreme Networks Summit WM User Manual page 54

Configuring the Summit WM Controller
Port # - The port number of the RADUS Server.
# of Retries - Number of times the Summit WM Controller tries to connect to the RADIUS Server
if the RADIUS Timeout interval is exceeded.
Timeout - Number of seconds the Summit WM Controller waits for a response from the RADIUS
Server before declaring timeout.
NAS IP address - The IP address of Network Access Server (NAS).
NAS Identifier - The Network Access Server (NAS) identifier. The NAS identifier is a RADIUS
attribute that identifies the server responsible for passing information to designated RADIUS
servers, and then acting on the response returned.
Auth Type - The authentication protocol type, whether PAP or CHAP.
Set as Primary Server - Specifies the Primary RADIUS Server when there are multiple RADIUS
servers.
You can modify any of the aforesaid values.
6 To add additional RADIUS servers, repeat Step 5.
NOTE
You can add up to three RADIUS servers to the list of login authentication servers. When you add two or more
RADIUS Servers to the list, you must designate one of them as the Primary server. The Summit WM Controller
first attempts to connect to the Primary Server. If the Primary Server is not available, it tries to connect to the
second and third server according to their order in the Configured Servers box. You can change the order of
RADIUS servers in the Configured Servers box by clicking on the Up and Down buttons.
7 To test the RADIUS Server's login configuration, click on Test. The following window appears.
54
Summit WM User Guide, Software Version 5.3