Extreme Networks Summit WM User Manual page 76

Configuring the Altitude AP
The Altitude AP can be reset to its factory default settings. For more information, see the Summit WM Maintenance
Guide.
Outdoor AP LED status
The following figure depicts the location of the LEDs on the Outdoor AP.
Figure 8: Outdoor AP LEDs
NOTE
Although the Outdoor AP has six LEDS, only R1, R2 and F LEDs are used in the current release. The remaining
LEDs are disabled.
The Center, Left, and the Right LEDs work in conjunction to indicate the general, high-level and
detailed state respectively.
The following table provides a composite view of the three LED lights of the Outdoor AP's state:
Table 9: Outdoor AP LED status
R1 LED R2 LED
Off Off
Blinking Green
Solid Green
Solid Green
Blinking Off
Green/
Yellow
Blinking Green/
Yellow
Solid Green/
Yellow
76
F LED Outdoor AP's detailed status
Blinking Red Initialization: Power-on-self test (POST)
Blinking Red Initialization: Random delay
Blinking Red Initialization: Vulnerable Period
Solid Red Reset to factory defaults
Blink Red WDS scanning
Blinking Red Network discovery: 802.1X authentication
Solid Red Failed 802.1X authentication
Blinking Red Network discovery: DHCP
Solid Red Default IP address
Blinking Red Network discovery: WM discovery/connect
Solid Red Discovery failed
Summit WM User Guide, Software Version 5.3