Extreme Networks Summit WM User Manual page 38

Configuring the Summit WM Controller
To configure the data port interfaces on the Summit WM Controller:
1 From the main menu, click Summit Controller Configuration. The Summit Controller
Configuration page is displayed.
2 In the left pane, click IP Addresses. The Interfaces page is displayed.
The upper portion of the Interfaces page displays the number of Ethernet ports of the Summit WM
Controller:
Summit WM1000 Controller - Two Ethernet ports
Summit WM100 Controller - Four Ethernet ports
Summit WM200/2000 Controller - Four Ethernet ports
Summit WM20 Controller - Two Ethernet ports
NOTE
For the Summit WM100 Controller, the footer of the Summit WM GUI does not include the link status of the
physical interfaces.
NOTE
All images of the Summit WM GUI in this User Guide represent the Summit WM200/2000 Controller.
3 Click a port.
Port configuration allows for the explicit state of the administration state for each interface. By
default, data interface states are enabled. If they are not enabled, you can enable them each of them
individually. A disabled interface does not allow data to flow (receive/transmit).
38
Summit WM User Guide, Software Version 5.3