Setting Up Multicast Configuration - Extreme Networks Summit WM User Manual

SpectraLink Wireless Telephones
10 Click Save.
The following screen-shot depicts how the configuration will appear in context of the network
topology illustrated in
NOTE
You must complete the remaining configuration as explained in the subsequent sections, and then check if the
deployment is working properly. If the deployment is working properly, you should deselect Allow option of the
Default filter in order to secure the network
The secure setup in context of the network topology illustrated in
- Allow 192.168.121.* UDP
- Allow 192.168.110.* UDP
- Allow 192.168.123.* UDP
- Disallow *.*.*.* N/A T

Setting up Multicast configuration

NOTE
Before you set up multicast configuration, you must specify the physical port for routing multicast traffic on the
Wireless Controller configuration screen (Wireless Controller Configuration>IP addresses).
To set up multicast configuration:
1 From the main menu, click WM Access Domain Configuration. The WM Access Domain
Configuration screen is displayed.
2 On the WM Access Domain Configuration screen, click the Multicast tab.
3 Select Enable Multicast Support.
4 From the Defined groups drop-down list, select Spectralink SVP (224.0.1.116) and then click Add.
372
Figure 34.
Figure 34 will be as follows:
Summit WM User Guide, Software Version 5.3