Summit Wm200/2000 Controller Back Panel - Extreme Networks Summit WM User Manual

Error conditions:
Table 32: LED states and SSD codes during error conditions
Warning
Active LED LED
Green
Green
Green
Green
Green
Green
Green
Green

Summit WM200/2000 Controller back panel

The following figure identifies the main components on the back panel of Summit WM200/2000
Controller.
Figure 29: Summit WM200/2000 Controller back panel
Redundant power supplies
Power switches
NOTE
The hardware for the Summit WM200 Controller and the Summit WM2000 Controller are identical.
Summit WM User Guide, Software Version 5.3
Error SSD
LED Code Condition
Red 1 Failed to identify FDD. Possibly due to removal of FDD card.
Red 2 Failed to initialize NPE card.
Red 3 Critical threshold reached (95C for NPE).
The system will reboot.
Red 4 Full fan assembly failure (both trays).
The system will reboot.
Red 5 Application initialization failure. Startup manager failed to
initialize all the components of the system.
The system will reboot.
Red 6 Lost connectivity with ethernet interface. Possible failure of
NPE card.
The system will reboot.
Red 7 MF 1000 card failure. Backup sectors exhausted.
Red 8 NP 4000 card initialization failure. Firmware self test (BIST)
has detected failure in one or more components (memory, bus,
interconnects)
333