Extreme Networks Summit WM User Manual page 236

Availability and session availability
recognizes the serial number, it sends the specific configuration (port and binding key) set for
that Altitude AP.
Allow only approved Altitude APs to connect - If the Summit WM Controller does not recognize
the serial number, the operator is prompted to create a configuration. Or, if the Summit WM
Controller recognizes the serial number, it sends the configuration for that Altitude AP.
NOTE
During the initial setup of the network, it is recommended to select the Allow all Altitude APs to connect option. This
option is the most efficient way to get a large number of Altitude APs registered with the Summit WM Controller.
Once the initial setup is complete, it is recommended that the security mode is reset to the Allow only approved
Altitude APs to connect option. This option ensures that no unapproved Altitude APs are allowed to connect. For more
information, see
8 To save your changes, click Save.
NOTE
When two Summit WM Controllers have been paired as described above, each Summit WM Controller's registered
Altitude APs will appear as foreign on the other controller in the list of available Altitude APs when configuring a
WM-AD topology.
9 Verify that the 'availability' feature is configured correctly.
To verify the 'availability' feature is configured correctly:
a From the main menu of either of the two controllers, click Reports and Displays. The Reports &
Displays page is displayed.
236
"Configuring Altitude AP settings" on page 84.
Summit WM User Guide, Software Version 5.3