Extreme Networks Summit WM User Manual page 235

3 To enable availability, select the Paired option.
4 Do one of the following:
For a primary controller, in the Summit Controller IP Address box, type the IP address of the
physical port of the secondary Summit WM Controller. This IP address must be on a routable
subnet between the two Summit WM Controllers.
For a secondary controller, in the Summit Controller IP Address box, type the IP address of the
Management port or physical port of the primary Summit WM Controller.
5 Do one of the following:
To set this Summit WM Controller as the primary connection point, select the Current Summit
Controller is primary connect point checkbox.
To set this Summit WM Controller as the secondary connection point, clear the Current Summit
Controller is primary connect point checkbox.
If the Current Summit Controller is primary connect point checkbox is selected, the specified
controller waits for a request. If the Current Summit Controller is primary connect point checkbox
is cleared, the specified controller sends a connection request. Confirm that one controller has this
checkbox selected, and the second controller has this checkbox cleared, since improper configuration
of this option will result in incorrect network configuration.
6 On both the primary and secondary controllers, type the Detect link failure value.
NOTE
You must ensure that the Detect link failure value on both the controllers must be identical.
7 To set the security mode for the Summit WM Controller, select one of the following options:
Allow all Altitude APs to connect - If the Summit WM Controller does not recognize the serial
number, it sends a default configuration to the Altitude AP. Or, if the Summit WM Controller
Summit WM User Guide, Software Version 5.3
235