Extreme Networks Summit WM User Manual page 178

WM Access Domain Services configuration
6 If applicable, to use a server that has already been used for another type of authentication or
accounting, click the server you want to use for MAC authentication, and then select User server for
MAC Authentication.
7 In the Port box, type the port used to access the RADIUS server. The default is 1812.
8 In the # of Retries box, type the number of times the Summit WM Controller will attempt to access
the RADIUS server.
9 In the Timeout box, type the maximum time, in seconds, that a Summit WM Controller will wait for
a response from the RADIUS server before attempting again.
10 In the NAS IP Address box, type the Network Access Server (NAS) IP address.
11 In the NAS Identifier box, type the Network Access Server (NAS) identifier. The NAS identifier is a
RADIUS attribute that identifies the server responsible for passing information to designated
RADIUS servers and then acting on the response returned. This is an optional step.
12 In the Auth. Type field, click the authentication protocol to be used by the RADIUS server to
authenticate the wireless device users for a Captive Portal WM-AD.
13 In the Password box, type the password you want to use for MAC-based authentication requests.
The password is forwarded by the Summit WM Controller to the authentication server. If the
Password box is left empty, the MAC address will act as the default password.
Toggle between Mask/Unmask to view and hide the defined password.
14 If applicable, select Set as primary server.
15 To enable MAC-based authentication on roam, select the MAC-based authentication on roam
checkbox.
178
Summit WM User Guide, Software Version 5.3