Setting Up Ospf Routing - Extreme Networks Summit WM User Manual

This report displays all defined routes, whether static or OSPF, and their current status.
3 To update the display, click Refresh.

Setting up OSPF Routing

To enable OSPF (OSPF RFC2328) routing, you must:
Define one data port as a router port in the IP Addresses page
Enable OSPF globally on the Summit WM Controller
Define the global OSPF parameters
Enable (or disable) OSPF on the port that you defined as a router port
Ensure that the OSPF parameters defined here for the Summit WM Controller are consistent with the
adjacent routers in the OSPF area. This consistency includes the following:
If the peer router has different timer settings, the protocol timer settings in the Summit WM
Controller must be changed to match, in order to achieve OSPF adjacency.
The MTU of the ports on either end of an OSPF link must match. The MTU for ports on the Summit
WM Controller is defined as 1500, on the IP Addresses page, during data port setup. This matches
the default MTU in standard routers.
To set OSPF Routing Global Settings on the Summit WM Controller:
1 From the main menu, click Summit Controller Configuration. The Summit Controller
Configuration page is displayed.
2 In the left pane, click Routing Protocols. The Static Routes tab is displayed.
Summit WM User Guide, Software Version 5.3
45