Viewing The Scanner Status Report - Extreme Networks Summit WM User Manual

Working with the Summit WM series Spy
NOTE
The selected APs are deleted from the Summit WM series Spy database, not from the Summit WM Controller
database. You can delete the APs from the Summit WM Controller database after you delete them from the
Altitude AP Configuration Access Approval page of the corresponding RF Data Collector Engine. You can also delete
the selected third-party APs if they are removed from the corresponding WM-AD in the RF Collector Engine, or if
that WM-AD has been deleted from the WM-AD list.

Viewing the Scanner Status report

When the Summit WM series Spy is enabled, you can view a report on the connection status of the RF
Data Collector Engines with the Analysis Engine.
To view the Summit WM series Spy scanner engine status display:
1 From the main menu, click Summit Spy. The Summit Spy page is displayed.
2 Click the Reports: Scanner Status. The Scanner Status report is displayed, as shown in the example
below.
The boxes display the IP address of the Data Collector engine. The status of the Data Collector engine is
indicated by one of the following colors:
Green - The Analysis Engine has connection with the Data Collector on that Summit WM Controller.
Yellow - The Analysis Engine has connected to the communication system of the other controller,
but has not synchronized with the Data Collector. Ensure that the Data Collector is running on the
remote controller.
Red - The Analysis Engine is aware of the Data Collector and attempting connection.
If no box is displayed, the Analysis Engine is not attempting to connect with that Data Collector Engine.
NOTE
If the box is displayed red and remains red, ensure your IP address is correctly set up to point to an active
controller. If the box remains yellow, ensure the Data Collector is running on the remote controller.
272
Summit WM User Guide, Software Version 5.3