Extreme Networks Summit WM User Manual page 41

b In the From box, type the starting IP address of the IP address range that you want to exclude
from the DHCP allocation.
c In the To box, type the ending IP address of the IP address range that you want to exclude from
the DHCP allocation.
NOTE
If you want to exclude just a single IP address from DHCP allocation, you must type the same IP address in the
From and To boxes.
d In the Comment box, type any relevant comment. For example, you can type the reason for
which a certain IP address is excluded from the DHCP allocation.
e Click on Add. The excluded IP addresses are displayed in the IP Address(es) to exclude from
DHCP Range box.
f To delete a IP Address from the exclusion list, select it in the IP Address(es) to exclude from
DHCP Range box, and then click Delete.
g To save your changes, click Save.
In the Gateway box, type the IP address of the default gateway.
NOTE
Since the Summit WM Controller is not allowed to be the gateway for the Altitude APs, you cannot use the
Interface IP address as the gateway address.
NOTE
The B'cast Address field is view only. This field is computed from the mask and the IP addresses.
Summit WM User Guide, Software Version 5.3
41