Setting The Parameters For The System Specifications - Mitsubishi Electric C80 Series Connection And Set Up Manual

C80 Series Connection and Setup Manual
12 Setting Machine Parameters

12.1 Setting the Parameters for the System Specifications

(1) On the Mainte screen, select [Mainte] and then [Psswd input]. Enter the machine parameter password in the setting
area and press the [INPUT] key.
(2) Go back to the Mainte screen.Then select [Param].
Set the parameters according to the system specifications.
"#1001 SYS_ON(System validation setup)"
"#1002 axisno(Number of axes)"
"#1003 iunit(Input setup unit)"
"#1004 ctrl_unit(Control unit)"
"#1005 plcunit(PLC unit)"
"#1006 mcmpunit(Machine error compensation unit)"
"#1037 cmdtyp(Command type)"
"#1039 spinno(Number of spindles)"
"#1155 DOOR_m"...Set to "100".
"#1156 DOOR_s"... Set to "100".
"#1511 DOORPm(Signal input device 1 for door interlock II: for each system)"
"#1512 DOORPs(Signal input device 2 for door interlock II: for each system)"
(3) After turning the power OFF and ON, select [Mainte] on the maintenance screen, switch the menu by the Menu
change button and then select [Format].
(4) When "Input the password" is displayed, enter the password for the machine parameter in the setting area and then
press [INPUT] key.
(5) When "Data protect" is displayed, select [I/F dia] on the Diagnosis screen, select [Modal output] and then enter
"Y70A/1".
(6) Select [Mainte] on the maintenance screen and then select [Format].
(7) When "Format NC memory? (Y/N)" is displayed, press "Y". "Format complete" will be displayed.
(8) Turn the power ON again and select [Mainte] --> [Psswd input] on the maintenance screen. Enter the password for
the machine parameter and then press [INPUT].
Select [Param] again on the Mainte screen. Set the following parameters.
"#1010 srvunit(Output unit(servo))"
"#1013 axname(Axis name)"
(Note) When the arbitrary axis exchange control is valid, set the axis names in "#12071 adr_abs[1]" to
"#12078 adr_abs[8]".
"#1021 mcp_no(Drive unit I/F channel No. (servo)))"
Set the following parameters as needed.
"#1014 incax(Increment command axis name)"
(Note) When the arbitrary axis exchange control is valid, set the increment command axis name in "#12079
adr_inc[1]" to "#12086 adr_inc[8]".
"#1015 cunit(Command unit)"
"#1017 rot(Rotational axis)"
"#1018 ccw(Motor CCW)"
"#1019 dia(Diameter specification axis)"
"#1020 sp_ax(Spindle interpolation)"
"#1022 axname2(2nd axis name)"
(9) Turn the power OFF and ON.
IB-1501452-C 172