Error Codes - Intermec 4630 User Manual

Error Message
SYNTAX ERROR 54
TRACE FAULT
TYPE FAULT

Error Codes

Most of the problems you may encounter with the 4630 and 4830 printers cause
the printers to send an error code to the host. If this happens, find the error
code in the table and complete the instructions to correct the problem.
Error
Code
00
01
02
04
05
06
07
08
11
12
13
21
22
23
24
25
26
27
28
Problem
Invalid UDC command.
The printer microprocessor has
detected an internal fault.
The printer microprocessor has
detected an internal fault.
Description
No error
Invalid bar code check character
Invalid number of bar code characters (Code UPC/EAN)
Bar code check character within numeric field marks
Supplemental delimiter within numeric field marks (Code UPC/EAN)
Invalid supplemental character count (Code UPC/EAN)
More than one supplemental delimiter (Code UPC/EAN)
Invalid start/stop characters (Codabar)
Invalid bar code data
Data count exceeded
Data is being entered into a non-data entry field
Quantity or batch count out of range
Field increment or decrement out of range
Intercharacter/message delay out of range
Missing preamble or postamble data
Invalid format transmission syntax
Invalid page transmission syntax
Invalid font transmission syntax
Invalid UDC transmission syntax
Troubleshooting
Solution
Correct the UDC command syntax.
Press Cont to clear the alert.
Contact your Intermec representative.
Contact your Intermec representative.
4
4-11