Testing The Reel Up/Down Activate Function Using The Cab Display Module (Cdm) - MacDon M155 Unloading And Assembly Instructions

4.8.2 Testing the Reel Up/Down Activate Function Using the Cab Display
Module (CDM)
NOTE:
•
This procedure is for draper headers only.
•
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display
module (CDM) to enter Programming Mode. Press
SELECT (B).
•
WINDROWER SETUP? is displayed on the
upper line.
3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
•
NO/YES is displayed on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
214298
CAB DISPLAY MODULE (CDM)
Figure 4.109: M155 CDM Programming Buttons
Shown – M205 Similar
Figure 4.110: M155 Diagnostic Functions
Shown – M205 Similar
196
Revision A