MacDon M155 Unloading And Assembly Instructions page 100

Attaching a D Series Header: Hydraulic Center-Link with Optional Self-Alignment
NOTE:
Draper header boots must be installed onto the windrower lift linkage before starting this procedure. Refer to
Attaching Header Boots, page
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Remove hairpin (A) from pins (B), and remove pins
from both header legs.
CAUTION
Check to be sure all bystanders have cleared the area.
2. Start the engine and activate the HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
214298
ASSEMBLING THE WINDROWER
85.
Figure 3.129: Header Leg
Figure 3.130: Ground Speed Lever
88
Revision A