MacDon M155 Unloading And Assembly Instructions page 205

3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
•
NO/YES is displayed on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
5. Press SELECT (B) until FORCE HEADER TYPE? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
SELECT HEADER TYPE is displayed on the
upper line.
•
DISK HEADER is displayed on the lower line.
7. Press left (A) or right (B) arrow to cycle through list of
header types.
8. When desired header type is displayed, press
SELECT (C).
•
EXIT FORCE HEADER? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
9. Press right arrow (B) to select YES. Press SELECT (C).
Proceed to next DIAGNOSTIC MODE or press
PROGRAM to exit Programming Mode.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.102: M155 Diagnostic Functions
Shown – M205 Similar
Figure 4.103: M155 Header Type Shown – M205
Similar
Figure 4.104: M155 Header Type Shown – M205
Similar
193
Revision A