5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
ACTIVATE HEADER HT is displayed on the
upper line.
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (B) until DRAPER DRV SPD XXXX is
displayed on the upper line.
IMPORTANT:
Do NOT overspeed the drapers.
8. Press and hold HAZARD (C) button.
•
Press left arrow (B) to decrease draper speed.
•
Press right arrow (D) to increase draper speed.
IMPORTANT:
Verify the draper drive is functioning properly.
9. Release the HAZARD (C) button. The drapers will stop.
10. Press PROGRAM (A) to exit Programming Mode or
press SELECT (E) to proceed to next ACTIVATE
FUNCTION.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.123: M155 Functions Shown – M205
Similar
Figure 4.124: M155 Draper Drive Shown – M205
Similar
203
Revision A