Configuring The Windrower; Setting The Header Knife Speed - MacDon M155 Unloading And Assembly Instructions

4.2 Configuring the Windrower

The windrower can be configured to meet changing crop conditions, activate newly added options, indicate a
change of header type, or increase your comfort level.

4.2.1 Setting the Header Knife Speed

NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
•
The current knife speed is displayed on the
lower line.
4. Press left (B) or right (C) arrows to select knife speed.
Press SELECT (D).
5. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.2: M155 CDM Programming Buttons
Shown – M205 Similar
Figure 4.3: M155 Knife Speed Shown – M205
Similar
145
Revision A