Testing Reel Up/Down Activate Function Using Cab Display Module - MacDon M155 2022 Operator's Manual

7. Press SELECT (D) until ACTIVATE HEADER HT appears on the
upper line.
• DOWN/UP will appear on the lower line.
8. Press and hold left arrow (B) to lower the header, or press
and hold right arrow (C) to raise the header. Ensure that the
header is working properly.
9. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next header function option.

Testing Reel Up/Down Activate Function Using Cab Display Module

The cab display module (CDM) can be used to change the height of the attached header's reel, rather than using the reel
height controls on the ground speed lever (GSL). This procedure is used to test the functionality of this feature.
NOTE:
• This procedure applies to windrowers with attached draper headers only.
• The header must be attached to the windrower to perform this procedure. The CDM automatically adjusts its
programming for each header. For more information, refer to
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode. Press SELECT (B).
• WINDROWER SETUP? will appear on the upper line.
215676
OPERATOR'S STATION
MXXX
A
B
Figure 3.179: Header Height
4.5 Attaching and Detaching Headers, page
MXXX
A
Figure 3.180: M155 CDM Programming Buttons
136
ACTIVATE HEADER HT
CXXX
DOWN/UP
WINDROWER SETUP?
CXXX
NO/YES
D
C
215.
B
Revision A