13. Remove lynch pin from clevis pin (A) in stand (B).
14. Hold stand (B) and remove pin (A).
15. Move stand (B) to storage position by inverting and
relocating onto bracket as shown. Reinsert clevis
pin (A) and secure with lynch pin.
16. Remove clevis pin from storage position (B) in linkage
and insert into hole (A) to engage float springs. Secure
with hairpin.
17. Disengage safety prop by turning lever (A) downwards
to release and lower stop until lever locks into vertical
position.
18. Repeat for opposite safety prop.
214298
ASSEMBLING THE WINDROWER
Figure 3.181: Header Stand
Figure 3.182: Header Float Linkage
Figure 3.183: Safety Prop
110
Revision A