MacDon M155 Unloading And Assembly Instructions page 123

CAUTION
Check to be sure all bystanders have cleared the area.
19. Start the engine and activate the HEADER DOWN
switch (A) on the GSL to fully lower the header.
20. Stop engine and remove key from ignition.
21. Connect header drive hoses (A) and electrical
harness (B) to header. Refer to the auger header
operator's manual.
Attaching an A Series Header: Hydraulic Center-Link without Self-Alignment
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Remove hairpin (A) from clevis pin (B) and remove
clevis pin from the header boots (C) on both sides of the
header.
214298
ASSEMBLING THE WINDROWER
Figure 3.184: Ground Speed Lever
Figure 3.185: Header Drive Hoses and Harness
Figure 3.186: Header Boot
111
Revision A