MacDon M155 Unloading And Assembly Instructions page 202

5. Press SELECT (B) until ENTER SENSOR SETUP? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
KNIFE SPEED SENSOR is displayed on the
lower line.
•
ENABLE/DISABLE is displayed on the lower line.
7. Press left arrow (B) to enable a sensor. Press right
arrow (C) to disable sensor. Press SELECT (D) to
confirm selection and move on to next sensor.
The following sensors are available:
• HEADER HT SENSOR
• HEADER TILT SENSOR
• KNIFE SPEED SENSOR
• REEL SPEED SENSOR
• HEADER FLOAT SENSOR
• OVERLOAD PRESSURE
• HYD OIL TEMP SENSOR
When sensors have been modified, press SELECT (D)
to display the EXIT SENSOR SETUP? selection.
8. Press right arrow (C) to select YES. Press SELECT.
9. Press PROGRAM (A) to exit Programming Mode or
press SELECT to proceed to next
DIAGNOSTIC MODE.
10. Requires installation of optional pressure sensor (MD #B5574).
214298
CAB DISPLAY MODULE (CDM)
10
190
Figure 4.96: M155 Diagnostic Functions Shown
– M205 Similar
Figure 4.97: M155 Header Sensors Shown –
M205 Similar
Revision A