MacDon M155 Unloading And Assembly Instructions page 137

4. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue driving
slowly forward until the feet engage the supports and
the header nudges forward.
5. Use the following GSL functions to position the
center-link hook above the header attachment pin:
•
REEL UP (A) to raise the center-link
•
REEL DOWN (B) to lower the center-link
•
HEADER TILT UP (C) to retract the center-link
•
HEADER TILT DOWN (D) to extend the center-link
6. Adjust position of the center-link cylinder (A) with the
REEL UP and REEL DOWN switches on the GSL until
the hook is positioned above the header
attachment pin.
IMPORTANT:
Hook release must be down to enable self-locking
mechanism. If the release is open (up), manually push it
down after hook engages header pin.
7. Lower center-link (A) onto the header with REEL
DOWN switch until it locks into position (hook
release [B] is down).
8. Check that center-link is locked onto header by
pressing the REEL UP switch on the GSL.
CAUTION
Check to be sure all bystanders have cleared the area.
214298
ASSEMBLING THE WINDROWER
Figure 3.220: Header Support
Figure 3.221: Ground Speed Lever
Figure 3.222: Hydraulic Center-Link
125
Revision A