MacDon M155 Unloading And Assembly Instructions page 135

M205 Self-Propelled Windrower
The M205 Self-Propelled Windrower is factory-equipped
with hydraulics and connections to run the R Series Rotary
Disc Headers.
The R85 16-foot header is factory-equipped with the
hydraulic connections for attachment to the windrower.
The R85 13-foot header and the R80 13- and 16-foot
headers are shipped without the motor and hoses installed
and the installation of a separate motor and hose bundle is
necessary.
If required, obtain Hydraulic Drive kit (MD #B5456) and
install it in accordance with the instructions supplied with
the kit.
Refer to the following instructions based on the type of
center-link installed on your windrower:
•
Attaching an R Series Header: Self-Aligning Hydraulic
Center-Link, page 123
•
Attaching an R Series Header: Hydraulic Center-Link
without Self-Alignment, page 129
Attaching an R Series Header: Self-Aligning Hydraulic Center-Link
1. Remove hairpin (B) from clevis pin (A) and remove
clevis pin from the header supports (C) on both sides of
the header.
214298
ASSEMBLING THE WINDROWER
Figure 3.215: M205 Hydraulic Drive Kit
(MD #B5456)
Figure 3.216: Header Support
123
Revision A