MacDon M155 Unloading And Assembly Instructions page 127

13. Install clevis pin (A) through support and foot and
secure with hairpin. Repeat for opposite support.
IMPORTANT:
Ensure clevis pin (A) is fully inserted and hairpin is
installed behind bracket.
14. Remove lynch pin from clevis pin (A) in stand (B).
15. Hold stand (B) and remove pin (A).
16. Move stand (B) to storage position by inverting and
relocating onto bracket as shown. Reinsert clevis
pin (A) and secure with lynch pin.
17. Remove clevis pin from storage position (B) in linkage
and insert into hole (A) to engage float springs. Secure
with hairpin.
214298
ASSEMBLING THE WINDROWER
Figure 3.195: Header Support
Figure 3.196: Header Stand
Figure 3.197: Header Float Linkage
115
Revision A