MacDon M155 Unloading And Assembly Instructions page 60

23. Remove clamp (A) from round plastic hose block (case
drain hose is preinstalled in block).
NOTE:
Case drain hose (C) is preinstalled in block.
24. Insert two left traction drive hoses (A) into hose block
as shown.
25. Insert two right traction drive hoses (B) into hose block
as shown.
26. Reinstall clamp.
27. Remove caps and attach hoses with short elbows (A) to
respective side of pump (either yellow or no tie). Tighten
fittings.
214298
ASSEMBLING THE WINDROWER
Figure 3.46: Hose Block
Figure 3.47: Hose Block (View Looking
Forward)
Figure 3.48: Pump
48
Revision A