MacDon M155 Unloading And Assembly Instructions page 187

6. Press left (B) or right (C) arrow to cycle between control
switch lockouts. The displayed control switches are as
follows:
• HEADER TILT
• HEADER FLOAT
• REEL FORE/AFT
• DRAPER SPEED
• AUGER SPEED
• KNIFE SPEED
• DISK SPEED
• REEL SPEED
NOTE:
Not all control locks apply to every header.
7. Press SELECT (D).
•
EXIT VIEW LOCKOUTS? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
8. Press right (C) to select YES.
9. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.62: M155 Control Locks Shown – M205
Similar
175
Revision A