MacDon M155 Unloading And Assembly Instructions page 125

4. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue driving
slowly forward until the feet engage the supports and
the header nudges forward.
5. Use the following ground speed lever functions to
position the center-link hook above the header
attachment pin:
• Header tilt up (A) to retract center-link
• Header tilt down (B) to extend center-link
6. Stop engine and remove key from ignition.
7. Push down on rod end of link cylinder (B) until hook
engages and locks onto header pin.
IMPORTANT:
Hook release must be down to enable self-locking
mechanism. If the release is open (up), manually push it
down after hook engages header pin.
8. Check that center-link (A) is locked onto header by
pulling upward on rod end (B) of cylinder.
214298
ASSEMBLING THE WINDROWER
Figure 3.190: Header Support
Figure 3.191: Ground Speed Lever
Figure 3.192: Hydraulic Center-Link
113
Revision A