5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
ACTIVATE HEADER HT is displayed on the
upper line.
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (E) until DISC DRV SPD XXXX is
displayed on the upper line.
IMPORTANT:
Do NOT overspeed the disc drive.
8. Press and hold HAZARD (C) button.
•
Press left arrow (B) to decrease disc speed.
•
Press right arrow (D) to increase disc speed.
IMPORTANT:
Verify the disc drive is functioning properly.
9. Release the HAZARD (C) button. The disc drive
will stop.
10. Press PROGRAM to exit Programming Mode or press
SELECT to proceed to next ACTIVATE FUNCTION.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.131: M155 Functions Shown – M205
Similar
Figure 4.132: M155 Disc Drive Shown – M205
Similar
207
Revision A