MacDon M155 Unloading And Assembly Instructions page 213

5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
ACTIVATE HEADER HT is displayed on the
upper line.
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (E) until KNIFE DRIVE SPD XXXX is
displayed on the upper line.
IMPORTANT:
Do NOT overspeed the knife drive.
8. Press and hold HAZARD (C) button.
•
Press left arrow (B) to decrease knife speed.
•
Press right arrow (D) to increase knife speed.
IMPORTANT:
Verify the knife drive is functioning properly.
9. Release the HAZARD (C) button. The knife will stop.
10. Press PROGRAM (A) to exit Programming Mode or
press SELECT (E) to proceed to next ACTIVATE
FUNCTION.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.119: M155 Functions Shown – M205
Similar
Figure 4.120: M155 Knife Drive Shown – M205
Similar
201
Revision A