Testing The Reel Up/Down Activate Function Using The Cab Display Module (Cdm) - MacDon M155E4 Unloading And Assembly Instructions

5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (D) until ACTIVATE HEADER HT is
displayed on the upper line.
•
DOWN/UP is displayed on the lower line.
8. Press and hold left arrow (B) to lower header, or press
and hold right arrow (C) to raise header. Verify header is
functioning properly.
9. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next ACTIVATE
FUNCTION.
5.9.2 Testing the Reel Up/Down Activate Function Using the Cab Display
Module (CDM)
NOTE:
•
This procedure is for draper headers only.
•
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
214738
CAB DISPLAY MODULE (CDM)
Figure 5.111: Functions
Figure 5.112: Header Height
102
Revision A