12. Position the two smaller hoses (MD #111323) (A) and
the two larger hoses (MD #111328, MD #111557) (B)
against the support as shown, and secure with
plastic ties.
13. Remove clamp (A) from round plastic hose block (case
drain hose is preinstalled in block).
NOTE:
Case drain hose (B) is preinstalled in block.
14. Insert two left traction drive hoses (A) into hose block
as shown.
15. Insert two right traction drive hoses (C) into hose block
as shown.
214298
ASSEMBLING THE WINDROWER
Figure 3.28: Hydraulic Hose Routing
Figure 3.29: Hose Block
Figure 3.30: Hose Block (View Looking
Forward)
42
Revision A